|
|
|
 If Will uses the word "dope", doesn't wear a larger FIRST logo, takes up half of the St. Louis arena, if there was not enough seating in the pits, if the music was killed during finals, it was all justified tonight. - Barry Bonzack [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
07-02-2007, 18:06
|
||||
|
||||
|
Re: question about Transmission axle's
BaneBots makes a bearing block that is reasonably priced. If you use the dual-motor adapter, the block you remove can be used by adding an inexpensive flanged bronze bearing (1/2" I.D. x 3/4" O.D.) and a spacer or shaft collar to keep it from backing out.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Transmission question | Team223 | Motors | 1 | 12-01-2007 13:23 |
| Question about drill transmission specs | ShadowKnight | Technical Discussion | 4 | 18-01-2005 00:14 |
| question about contacts | robot180 | Chit-Chat | 37 | 27-09-2003 22:40 |
| Question about splines | Daishichimaru | 3D Animation and Competition | 2 | 22-01-2003 09:20 |
| Question about wheels | Randy_Ai | Technical Discussion | 9 | 24-01-2002 17:14 |
Threaded Mode