|
|
|
 I normally prefer my speed controllers to brake, rather then break. - Joe Ross [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I normally prefer my speed controllers to brake, rather then break. - Joe Ross [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Motor problems
Hello,
We have an arm that weighs about 6 pounds that is mounted on two posts. It rotates on a rod that is about 4" from the end of the robot. That arm has a gear attached to it and a chain leading to a window motor. However once the arm gets past center it can't control the arm, and thus the arm comes "crashing," in a sense, down. The motor has a worm gear, yet it can't stop the motor momentum. Is there some motor that we can get that has a stronger worm gear? I will get the motor name and number once we get to school later today. It is a motor from a few years ago, with an 11mm shaft that turns into a screw end, if that helps any veterans. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Annoying motor problems... | jazzsaxman1988 | Programming | 8 | 03-02-2005 08:49 |
| Drill Motor + Gearbox + Breaker Problems | sear_yoda | Electrical | 28 | 03-03-2004 20:03 |
| More drill motor problems, jeeze. | blindguy | Motors | 4 | 12-02-2003 09:06 |
| chapita motor problems | lockportcew | Motors | 2 | 05-06-2002 11:16 |
| Drill Motor Gearbox Problems... | Jim Meyer | OCCRA | 1 | 16-10-2001 06:17 |
Threaded Mode