|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Encoder Problems
I'm trying to use an the Kit GTS with the encoder code. I took out the Phase B from my code and upload it to the robot. It runs 2-3 loops and then I get a code error. When I try to upload the default encoder code it gives me a code error without running any loops. Please help
|
|
#2
|
||||||
|
||||||
|
Re: Encoder Problems
It's impossible to help without seeing your code.
|
|
#3
|
||||
|
||||
|
Re: Encoder Problems
Its OK I fixed the problem thanks!
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Labview problems and code problems | ajsetter | Programming | 25 | 18-01-2006 17:07 |
| Encoder Output Problems | Mike | Electrical | 5 | 25-11-2005 21:43 |
| encoder.c | Gary Bonner | Programming | 2 | 14-01-2005 13:41 |
| Problems counting encoder pulses | bludstayne | Programming | 7 | 02-02-2004 23:07 |