Rotating Servo HS322 over 90 degrees

10-02-2007, 19:45

brennerator brennerator is offline

Registered User

#1560

Join Date: Jan 2005

Location: Silicon Valley

Posts: 75

brennerator is an unknown quantity at this point

Rotating Servo HS322 over 90 degrees

Basically I have this servo and I want to rotate it along its entire range of motion. I have the default code, and I set pwm 11 for this servo.

if (p1_sw_trig ==1)
{
pwm11 = 255;
}
if (p1_sw_top == 1)
{
pwm11 = 0;

This is so that we can upshift and downshift....

Thanks.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Servo Values to Degrees... How?	mogunus	Programming	16	11-04-2007 02:03
How do you get servo numbers into Angle Degrees	Cow Bell Solo	Programming	3	18-02-2007 12:16
engineering degrees	sciguy125	Career	18	17-03-2006 23:44
Turn 90 Degrees	Mike	Math and Science	16	05-12-2004 22:22
Rotating Light - not rotating :-/	MrB	Technical Discussion	17	08-02-2002 20:36

All times are GMT -5. The time now is 04:47.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.