Chicklet-issues

[Mike Copioli]

Originally Posted by mattg101

I believe I have a usb-chicklet problem. I am using the logitech 3d extreme, p/n 863225-1000. For some reason I am not getting correct pwm values outputting to the robot. When I pull back on the y-axis, I am getting different pwm values for pwms which should be the same. When I push forward on the y-axis everything is ok. This problem only occurs on the y and r axises. I have gone through the calibration mode twice with not difficulty. When I use a analog joystick without the usb-chicklet I have not problems. I just bought to logitech joystick 2 weeks ago. Any suggestions?

Follow Jims suggestions and use dashboard to verify the data from the Chicklet.

[T3_1565]

how do you verify output with the dashboard (it may seem like a dumb question but I'm no programmer )

[fimmel]

on the OI there is a small jumper next to the dashboard port. switch that to "OI" when you have done that connect the OI to a RC and power it up. then open IFI's Dashboard viewer. the display should show all of the OI inputs. there is where you can see the outputted data from the chicklet.

hope that helps

/forest