|
|
|
 Overall... the secret is PROTOTYPING! Design is an iterative process. Do some basic design in your head. Build it. Test it. Improve it. Repeat until satisfied. - JVN [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Size of Hole for 1/8-27 NPT Brass Plugs
I'm designing a piece of tooling that will require brass plugs to be put into it. I'm going to use plugs that will sit flush with the edge of the fixture. I've ordered the 1/8-27 NPT brass plugs, but I'm not sure what size hole I've got to drill for the tap. If you can help me out, I'd appreciate it.
Thanks, indieFan |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Servo Plugs | CapnBFG | Electrical | 9 | 12-07-2005 22:31 |
| Band Plugs | Petey | Chit-Chat | 3 | 31-01-2005 22:06 |
| soleniod plugs | Michael Long | Pneumatics | 5 | 21-02-2003 21:20 |
| BRASS COLORED HINGE | archiver | 2001 | 2 | 24-06-2002 01:04 |
| Brass Gears and Titanium | Chubtoad | Technical Discussion | 3 | 16-01-2002 09:48 |
Threaded Mode