|
|
|
 There hasn't been an announcement to buy pool noodles yet. Considering that they are already out of stores in most of the country, draw whatever conclusion that you like. - Joe Ross [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
15-02-2007, 22:39
|
|||
|
|||
|
Re: SERIOUS Issues With Keyangs, Bending/Twisting Drive Shafts
Try connecting both to 1 victor, so they will definitely stay in sync. Since the stall current of the Keyangs is 20 amps each, 2 will not blow out a victor.
If you want to be sure about the bias,mark the shaft, run them each way for a minute, and count revs. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help! Direct Drive Issues | roberthan | Motors | 16 | 21-09-2006 09:33 |
| Flexible shafts working with CIMs | mechanicalbrain | Motors | 8 | 07-07-2006 23:38 |
| Issues with MPLAB 7.30 | gnirts | Programming | 4 | 25-01-2006 22:57 |
| Shorten The Flexible Drive Shafts? | milesdf | Motors | 2 | 08-02-2004 12:27 |
| Connecting 2 Keyangs to a Victor? | Jim Meyer | OCCRA | 3 | 14-10-2001 20:33 |
Threaded Mode