|
|
|
 One of my management professors taught me this: At all times you are holding a bucket in each hand, one full of water, and one full of gasoline. Management is knowing when to throw which bucket. - Barry Bonzack [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Wire Schematic
The Schematic says that the red from the main power kill switch goes to the power distribution block, which then goes to the maxi breaker. Are we allowed to go from the power kill switch straight to the maxi?
|
|
#2
16-02-2007, 16:18
|
||||
|
||||
|
Re: Wire Schematic
No, the power distribution block must be used.
Also see http://www.chiefdelphi.com/forums/showthread.php?t=53437&highlight=power+distributio n+block Last edited by AJ R : 16-02-2007 at 16:55. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FRC Electrical schematic | Demothesis | Control System | 2 | 07-01-2007 13:31 |
| Schematic | Spica | Control System | 9 | 30-12-2006 13:00 |
| Analog Joystick Schematic | DonRotolo | Control System | 4 | 13-03-2005 22:06 |
| Robot Electrical Schematic | CHSguard72 | Electrical | 5 | 03-03-2003 21:30 |
| drill gearbox schematic? | Jeff Sharpe | Technical Discussion | 3 | 21-01-2003 00:18 |
Linear Mode
