Problem with the Victors

[Alan Anderson]

I'm guessing you have your Victors connected improperly. Make absolutely sure that the + input is coming from a circuit breaker, the - input is going to a good negative "ground" point, and the M+ and M- pins are going to two sides of the same motor. Check for short circuits between the motor connections.

[DHarris]

Ah, they were connected improperly. It turns out that our mechanic re-connected them the wrong way after we got the robot back from Kimberly-Clark. Thanks.

Heh, we have about $600 worth of Victors that we probably can't use now though =/

[eshteyn]

Originally Posted by DHarris

Ah, they were connected improperly. It turns out that our mechanic re-connected them the wrong way after we got the robot back from Kimberly-Clark. Thanks.

Heh, we have about $600 worth of Victors that we probably can't use now though =/

I suggest u hook them up to a battery and a multi-meter and check, our victors did that once and they work absolutely fine now

[RedHeadRobotics]

My suggestion would be to use a smaller circuit breaker, like a 20 amp instead of a 30 amp, and using a bigger wire size. The rules have the bar minimum wire size, we always try to go one bigger. Good luck, I hope you figure out the problem.

[Al Skierkiewicz]

Dana,
You may be able to get them repaired by IFI for less than a replacement. Contact them to help you make a decision.