|
|
|
 geeez....and i was going to say they should knock a week off the build season. - johnr [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| geeez....and i was going to say they should knock a week off the build season. - johnr [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
18-02-2007, 17:07
|
|||
|
|||
|
Re: Gear tooth sensor orientation
We have gear tooth sensors mounted in a variety of orientations and they all work well. The important thing to remember is that you must have the active face of the sensor lined up with the gear as shown on page 5 of the datasheet: http://www.allegromicro.com/datafile/0642.pdf
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gear Tooth Sensor | Zoom | Programming | 46 | 22-01-2008 08:05 |
| Gear Tooth Sensor? | Raikon | Kit & Additional Hardware | 3 | 09-02-2007 16:40 |
| Gear Tooth Sensor | nukem | Programming | 9 | 04-02-2006 20:21 |
| Gear Tooth Sensor | Talha | Electrical | 1 | 23-01-2006 21:29 |
| Gear Tooth Sensor | AMIRAM | Electrical | 2 | 22-01-2006 04:09 |
Threaded Mode