|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
|||||
|
|||||
|
Re: Team 1351 Ramp Design Help
Our ramp is approximately 12 degrees and goes up 8 inches onto a platform and we use two 2-inch diamater pistons to lift the robot the remaining four inches. It is made out of grating and 1-inch Aluminum angle.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Transmission Design Help | JoelP | Technical Discussion | 8 | 24-04-2006 16:59 |
| Ramp help | Tim566 | General Forum | 39 | 28-03-2006 15:35 |
| pic: 1351 teaser | sciguy125 | Extra Discussion | 7 | 29-01-2006 15:23 |
| pic: 1351 Teaser | Paolo | Extra Discussion | 1 | 07-02-2005 17:34 |
| pic: 1351 camera mount | sciguy125 | Robot Showcase | 6 | 05-02-2005 09:11 |