SERIOUS COMPRESSOR PROBLEM

[simeon1770]

ok,

1.how does the secondary regulator, and the flow control valve look? picture? also how do u set it to 32 psi?

2. how do i turn the spike off, even when thespike wasnt hooked up in a pwm slot it was still sucking, but notihave it in digital output 1

[Ari Allyn-Feuer]

Originally Posted by simeon1770

ok,

1.how does the secondary regulator, and the flow control valve look? picture? also how do u set it to 32 psi?

2. how do i turn the spike off, even when thespike wasnt hooked up in a pwm slot it was still sucking, but notihave it in digital output 1

The secondary regulator is a hardware device put in series with the solenoid in the line, before it. It has a physical knob you use to set the pressure. That should be in the Pneumatics manual.

You shouldn't have a solenoid valve hooked up to a digital I/O pin; it should be on a relay output. Then to turn on the vacuum cups you do something like

relay2_fwd=1;
relay2_rev=0;

And to torn them off you do something like

relay2_fwd = relay2_rev = 0;

I hope this helps,

Ari.