Pneumatic Cylinder - Chief Delphi

As a famous saying goes, don't criticize someone till you have walked a mile in their shoes. - Steve W [more]

		Chief Delphi > Technical > Technical Discussion
Pneumatic Cylinder

Thread Tools

Rate Thread

Display Modes

19-02-2007, 21:28

yanksrock777 yanksrock777 is offline

Registered User

FRC #1468 (J-Birds)

Join Date: Feb 2006

Rookie Year: 2004

Location: Hicksville

Posts: 9

yanksrock777 is an unknown quantity at this point

Pneumatic Cylinder

My team has a pneumatic cylinder that has been mounted almost vertically. The problem is that we need more of a lateral push rather than a vertical push. Now I was thinking we could fabricate a metal piece, some type of bracket that we could take that vertical push and transfer it into the direction that we need it. Any suggestions on what we could do? Some time of L shaped aluminum or something of that sort? In case you were wondering it is a pneumatic cyclinder to push out the ramps.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Pneumatic cylinder size	bruss6	Pneumatics	8	16-02-2007 16:37
pneumatic cylinder part numbers	Ed Crammond	Pneumatics	0	14-02-2003 19:27
Pneumatic Cylinder i-Factory Model Posted	Ed Sparks	Inventor	0	12-01-2003 23:27
Pneumatic Cylinder Length	billy	Technical Discussion	2	10-01-2003 08:30
2" Pneumatic Cylinder Posted	Ed Sparks	General Forum	0	27-01-2002 15:47

All times are GMT -5. The time now is 13:24.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.