|
|
|
 A poor robot with good drivers playing on good strategy will whomp a good robot with poor drivers running on poor strategy any day. - henryBsick [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| A poor robot with good drivers playing on good strategy will whomp a good robot with poor drivers running on poor strategy any day. - henryBsick [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
23-02-2007, 23:10
|
|||||
|
|||||
|
Re: [FVC]: Servo motor fix
chances are the pot is stuck in one direction, causing it to continuously spin in that direction.
did you take out the pot? i'm aware of the fact that after fixing the servo mechanically-or removing the plastic stub piece that sticks out of one gear- you should replace the potentiometer with two 2.2k resistors. the potentiometer has 3 pins. remove the wires from each pin(desoldering probably) and replace the outer pins with said resistors to the outer wires and the other ends of each resistor to the middle pin. i may be a bit vague, but thats how I do it. i would just go with a normal motor if i were your team though, just to be safe. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FVC]: Can you change a vex servo to motor? | Marcel | FIRST Tech Challenge | 6 | 02-02-2007 14:41 |
| 698's Fisher Price Motor Fix | Alex698 | Motors | 10 | 13-10-2006 19:55 |
| FVC 2005 in Servo Magazine | syraweb | FIRST Tech Challenge | 0 | 16-02-2006 15:11 |
| Motor to Servo | itzrobz | Programming | 8 | 02-02-2006 16:11 |
| Defective clutch on motor/servo? | jeffmorris | FIRST Tech Challenge | 3 | 04-10-2005 14:49 |
Threaded Mode