|
|
|
 There is more to our team than my hair, you know. :P - thefro526 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| There is more to our team than my hair, you know. :P - thefro526 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
24-02-2007, 15:07
|
|||
|
|||
|
Re: Vacuum cutoff solenoid
After staring at the drawing of the internal paths, I am guessing that the PE and X ports are for venting pilots' pistons and therefore would not work for providing external pilot pressure. SMC has other valve models that are designed for this. The internal pilot pressure path branches off of the P port at the top of the valve body. The PE and PX ports vent off the backside of the actuating pistons allowing them slide back and forth.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vacuum Valve | Andrew Blair | Pneumatics | 14 | 12-03-2007 19:49 |
| Vacuum Generator | Peter Matteson | Technical Discussion | 0 | 04-02-2005 15:58 |
| Vacuum | NoRemorse | Rules/Strategy | 25 | 22-01-2004 12:34 |
| Vacuum | nwagers | Pneumatics | 16 | 31-10-2003 15:57 |
| thermal cutoff protection on VanDoor Motor | archiver | 2001 | 1 | 24-06-2002 01:02 |
Threaded Mode