|
|
|
 I saw a big opening in the bees section and asked if we could sit for this match and was told we were welcome to sit there. Your team made space for about 15 of my team members that came with me. - Debbie [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
27-02-2007, 11:12
|
|||||
|
|||||
|
Re: Worm Gear
Quite easily, as long as ou have the worm and a worm gear. Bore out the worm to 8 mm and them fasten it somehow to the CIM shaft, either pins through or a key way. If the gear reduction still is not enouph, try a initial gear reduction with spur gears. Hope this helps.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Worm Gears | FIRST JerseyKid | Technical Discussion | 13 | 18-01-2006 10:13 |
| worm gear emergency | ClicheCow | Technical Discussion | 5 | 21-02-2005 01:39 |
| Van Door Motor Worm Gear | Anthony | Motors | 5 | 14-02-2005 07:33 |
| Worm Gear Gearbox | dddriveman | Technical Discussion | 38 | 07-01-2005 14:43 |
| Van Door Worm Gear | Jim Giacchi | Motors | 4 | 16-12-2003 09:35 |
Threaded Mode