Could you make it on?

AdamHeard · #1 27-02-2007, 18:30

We can do that with no problems.

Not only can we make large angled ramps, we can drive onto a 4 inch platform.

VanMan · #2 27-02-2007, 18:35

Is your robot design to lift wide or narrow aspect? Or both? Ours can lift both but maybe the panels where the wheels go are too small.

Vikesrock · #3 27-02-2007, 18:43

Quote:

Originally Posted by VanMan

Is your robot design to lift wide or narrow aspect? Or both? Ours can lift both but maybe the panels where the wheels go are too small.

If a wide robot can fit it is welcome to, but due to the width of the panels, 32" max" and the cables, 36" apart max, we recognize it is HIGHLY unlikely that any wide driving robot will be able to fit inside.

#4 27-02-2007, 19:43

Our bot will fit fine. We use bumpers as a slight ramp to allow our low riding drivetrain to get over lips.

View Poll Results: Can your robot make it up our platform?
Yes, no problem	48	60.00%
Yes, but with a running start	12	15.00%
Not Sure	13	16.25%
No way!	7	8.75%
Voters: 80. You may not vote on this poll

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
If you could make your own...	lukevanoort	Control System	12	10-05-2006 17:04
Did you make friends at a regional.. but dont know if you will ever see them again?	Ashley Christine	General Forum	66	10-04-2005 17:25
If you could take one FIRST-related picture of you...	Billfred	Chit-Chat	11	11-12-2004 16:22
Could you make me some Mac floppies?	sanddrag	IT / Communications	1	12-09-2004 22:53
if you could have what you want...	Greg Perkins	Rumor Mill	33	06-09-2002 11:30