|
|
|
 Mentoring is HARD. - Akash Rastogi [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Mentoring is HARD. - Akash Rastogi [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
PO Channels
Hey I presented in the NASA conference today in Providence RI. I had a major problem, that I couldn't run the robot, because the user brain, or the user controller, was keep restarting the PO channels. And it would never link up. I think that it is being jammed on something at the same frequency in the convention center. Bob was there from Buz robotics, and he contacted Mike from Buz to try to help me. He said to to change the team number on the user brain, and to make sure that it was set to the same on the robot brain. I did that but I was still getting the same results. Any suggestions?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| R/C Control types | Andy Brockway | Programming | 43 | 24-11-2003 17:07 |
| 2003 IRI | David Kelly | Off-Season Events | 266 | 24-07-2003 22:09 |
| nats: stoping conflicting robot signals? | JasonStern | Technical Discussion | 25 | 25-05-2003 00:37 |
| communication errors at national | Adams High Man | Electrical | 15 | 16-04-2003 14:22 |
Threaded Mode