|
|
|
 When it comes to FIRST (you've all heard the cliche) -- we're all winners.
When it comes to the competition: to the engineering design challenge, we're NOT all winners -- some solutions are better than others. - JVN [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
03-07-2007, 06:28 PM
|
||||
|
||||
|
Re: pic: Banebots carrier plates problem & solution
To add what I forgot to tell elgin:
1. That picture of the pins out are of a NEW carrier plate, not the old one. The plates were installed friday morning and the gearboxes were opened that afternoon to change to a dual transmission setup. I think that comes to only 6 matches played with the new plates in. 2. We measured the top of the hole, and the bottom of the hole. the top of the hole were the pin was allowed to move was ovaled out and .02 inch different then the bottom of the hole. Hopefully this fix helps some of you, I would recommend taking a peak into the gearbox to see if you have this situation before it becomes a serious problem. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Anyone lost thier BaneBots Carrier pins? | StevenB | Technical Discussion | 50 | 03-30-2007 12:40 AM |
| pic: Carrier plate | deathbycornchip | Extra Discussion | 2 | 02-18-2007 10:51 AM |
| HELP needed, problem with streamling, need uploading space or diffrent solution... | Nimmy | General Forum | 5 | 02-15-2006 11:18 AM |
Threaded Mode