|
|
|
 I will follow FIRST's guidelines, as long as they conform with those of the English language. - artdutra04 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I will follow FIRST's guidelines, as long as they conform with those of the English language. - artdutra04 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Using two motors in the tandem
We are considering using the Denso Window Motor and the globe motor together on the same chain. One has a free RPM of 85 and the other 82.
Will this cause problems? With the close RPM, I don't think it should create a huge issue. Of course we were worried about one trying to drive the other - but we're going to use a y-PWM cable with victors for each. I suspect it won't have a problem with the match lengths we're talking about. Has anyone out there done something similar? The globe says it has a 150 in-lb of torque which is 16.9 Nm. The window motor has 12 Nm. We are only going to turn them through 1/2 a rotation. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FVC]: MPLab using two transmitters | emmell | FIRST Tech Challenge | 2 | 24-02-2007 00:33 |
| Using two CIMs in the Banebots Transmission | Justin M. | Technical Discussion | 15 | 09-01-2007 09:41 |
| Problem using two transmitters | jamesgecko | FIRST Tech Challenge | 9 | 12-05-2005 09:30 |
| Is Anyone Using Motors to Hoist themselves off the platform on the bar? | xxlshortys | Motors | 36 | 25-02-2004 01:06 |
| Using two Large PAPST Fans? | SuperDave | Electrical | 9 | 17-02-2003 15:11 |
Threaded Mode