|
|
|
 It'd be nice if, one day, people just concentrated on how to inspire your own team and your own community. Let others decide on how to inspire theirs. - George1902 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It'd be nice if, one day, people just concentrated on how to inspire your own team and your own community. Let others decide on how to inspire theirs. - George1902 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
12-03-2007, 20:53
|
|||||
|
|||||
|
Re: Machining plastics with CNC
Delrin machines very well ,but can be problem if you you are going paint it.
You might try high density foam board (renshape ) not sure of the spelling. I would also suggest buy a roll of 3M carpet tap .When machining plastics they tend to warp badly.Two sided carpet tap work great to hold the material .Make sure everything is very clean.cut light and fast. You should post a picture of what you want to cut ,I some different material around my shop.If you have the size I might be able to send you the material. jim schaddelee Last edited by Jim Schaddelee : 12-03-2007 at 20:56. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I need help with plastics | mechanicalbrain | Technical Discussion | 13 | 14-06-2006 11:15 |
| just wondering [g code cnc machining] | [527]phil | Technical Discussion | 16 | 17-10-2004 17:21 |
| To CNC? Or not to CNC? | phrontist | General Forum | 21 | 26-03-2004 13:45 |
| Website on basic machining | Adam Y. | Technical Discussion | 1 | 02-01-2004 20:12 |
| Machining | jrgrim12 | Technical Discussion | 21 | 07-01-2003 22:41 |
Threaded Mode