2007 Boilermaker Regional!!!

[kramarczyk]

Originally Posted by KTorak

That was on a drive wheel, right? What kinda of setup were you using. We used aluminum shafts and keys, but we just used 1 CIM and an AndyMark (similar to 2006 KOP) transmission. We also then reduced it by 1/3 and used a belt drive system.

Yeah it was a center drive wheel... anything else and we probably could have pulled the chain and continued.

Our drivetrain was 6x6 - 2 CIMS a side into AM servo shifters buried in our rails. With the additional reduction from sprockets we were running ratios of 10.0 in high and 25.6 in low. All the components are (were) aluminum... 5/8 igus shafting and IFI sprockets with hubs welded on.