|
|
|
 I also hate it when I keep seeing this message: "You must spread some Reputation around before giving it to Andy Baker again." - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I also hate it when I keep seeing this message: "You must spread some Reputation around before giving it to Andy Baker again." - dlavery [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
19-03-2007, 17:22
|
||||
|
||||
|
Re: pic: The 2007 Team 703 Phoenix Robot
I have always liked 703's drive train and design sensibilities in general...keep up the good work! I was trying to get 461 to use carbon fiber/nomex panel for the ramps but it didn't work out.
What is the "sandwiched" material in your panels? Nomex? Aluminum? Something else? 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Team 968 - 2007 Robot | Travis Covington | Extra Discussion | 16 | 06-03-2007 20:10 |
| pic: Team 1345's 2007 Robot, The Condor. | Arefin Bari | Robot Showcase | 22 | 23-02-2007 20:18 |
| pic: Team Phoenix - 703 at Buckeye | MattB703 | Extra Discussion | 1 | 03-04-2006 15:57 |
| pic: Team 703 Phoenix | POLISH703 | Robot Showcase | 6 | 07-03-2005 12:39 |
| pic: Phoenix 703 "almost done" | MattB703 | Robot Showcase | 13 | 16-02-2005 14:34 |
Threaded Mode