|
|
|
 I thanked the tradesmen on our team the same way i do ever year with a handshake and a "thanks for helping us guys",
- Mike Schroeder [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I thanked the tradesmen on our team the same way i do ever year with a handshake and a "thanks for helping us guys",
- Mike Schroeder [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
20-03-2007, 16:02
|
||||
|
||||
|
Re: Simple Swerve/Crab
I'm not sure what is "best" really depends on what you are using and how, but last year ours were made from bent 1/8" ours were surrounded by 1X1 square extrustion
module http://flickr.com/photos/jskowski/91...7594544781064/ frame: http://flickr.com/photos/jskowski/99...7594544781064/ good luck |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Swerve/Crab | Rob2713g | Technical Discussion | 5 | 12-11-2006 22:05 |
| pic: Swerve! | =Martin=Taylor= | Extra Discussion | 15 | 07-07-2006 01:58 |
| Crab/Swerve/Synchro Pics | Joe_Widen | Technical Discussion | 6 | 15-04-2006 20:54 |
| Swerve/crab drive and tank turning | activemx | Technical Discussion | 9 | 23-02-2004 18:26 |
| Swerve Drive | Jeff Waegelin | Technical Discussion | 14 | 17-09-2001 08:06 |
Threaded Mode