|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
||||
|
||||
|
Re: Aluminum Welding Flux?
Hello,
You will not have a whole lot success with an Oxy -Arc torch with or without flux....very difficult and experience needed to control the heat as you are experiencing easily welded w/ Gas Tungsten arc using Argon Gas and either (4043 or 6061 - filler material or Gas Metal arc welding.....email me with any further questions.. Scott Welding Engineer Last edited by DDAwg3 : 25-03-2007 at 23:18. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Welding Aluminum MIG or TIG? | Arkorobotics | Technical Discussion | 15 | 01-02-2007 13:17 |
| ARC Welding Aluminum | Simon Strauss | Technical Discussion | 12 | 20-09-2006 19:45 |
| Stick Welding Aluminum | sanddrag | Technical Discussion | 2 | 02-02-2006 13:17 |
| MIG Welding Aluminum | sanddrag | Technical Discussion | 11 | 15-09-2005 13:50 |
| Magnetic Flux | Keith Chester | Math and Science | 3 | 11-04-2005 09:35 |