|
|
|
 At least try to make sure other teams are aware of you. Don't be obnoxious, but don't be a wall flower either. - Joe Johnson [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| At least try to make sure other teams are aware of you. Don't be obnoxious, but don't be a wall flower either. - Joe Johnson [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
Banebot 56mm transmissions are Available
 Several hundred 56mm transmissions are available from Banebots for shipping. They are coming through with hardened carrier plates and the correct length pins. They can be overnighted for you to receive them before you leave for Nationals, so you won't have to depend on another team for spares. They also have many of the hardened carrier plates with the shorter pins available for those of you that want to re-drill and install new, correct length pins in between the existing locations as I posted earlier. For your information, and according to Banebots, the new transmission carrier plates are hardened to RC-23, the same hardness as the output shafts. The replacement carrier plates with the short pins are hardened to about RC-42.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Banebot 56mm Gearbox - Repair Docs & FAQ | kmcclary | Motors | 0 | 22-02-2007 01:47 |
| Banebot 56mm gearbox - double D - V3 - It's Show Time. | Joe Johnson | Motors | 34 | 18-02-2007 19:00 |
| Banebot 56mm gearbox - double D - RELOADED | Joe Johnson | Motors | 82 | 09-02-2007 14:07 |
| Banebot 56mm gearbox - double D related | Joe Johnson | Motors | 78 | 31-01-2007 23:55 |
| Attempting to Cut BaneBot 56mm Shaft | edthegeek | Motors | 6 | 15-01-2007 08:51 |
Threaded Mode