|
|
|
 Sometimes you don't need a lot of power, just the will to move. - Al Skierkiewicz [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Sometimes you don't need a lot of power, just the will to move. - Al Skierkiewicz [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
08-04-2007, 13:11
|
||||
|
||||
|
Re: Servo Controller Power Issues....
If it didn't recognize the data the LED would be red. But I took out my multimeter out once AGAIN, and hooked it up to the battery to look at voltage. And this time I did notice the voltage getting below 5 volts. I could barely see it though because the display is so fast. I guess I would have been able to see it better with something that would record and graph it. I am guessing this is the problem. I guess it also explains why it resets when I turn the servo. Because I am stalling the motor and cause a big current draw. I was figuring this was the problem yesterday, but I didn't see any proof of with on my multimeter. Thanks for taking to time to look at the manual and help me out.
When I get better batteries I will report back. -John Last edited by John Gutmann : 08-04-2007 at 13:13. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vex Controller Issues | spsteam1512 | VEX | 6 | 19-02-2007 16:56 |
| Power issues...Electrical? Mechanical? | Rhubarb | Technical Discussion | 24 | 08-03-2006 17:20 |
| Direct control of a Servo or Speed Controller | Schmitty! | National Instruments LabVIEW and Data Acquisition | 3 | 06-03-2006 13:53 |
| Additional basic stamp servo power supply | John Gutmann | Electrical | 11 | 21-09-2005 21:45 |
| Drill Motor/Speed Controller/Who Knows What Issues | GMitchell | Motors | 12 | 28-01-2003 17:11 |
Threaded Mode