|
|
|
 We don't have to reinvent the wheel every year. (We have AndyMark to do that for us.) - GaryVoshol [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| We don't have to reinvent the wheel every year. (We have AndyMark to do that for us.) - GaryVoshol [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
20-04-2007, 16:12
|
|||||
|
|||||
|
Re: Piranha 36:1 Gearbox for FP?
Testing would probably have to be done on these. The site says that they are designed for use in 12-15 lb robots, while ours are 100-150 lbs. It wouldn't be ideal for drive. Other than that though, its output shaft speed is in a pretty good range. With a 6" wheel, its freeload speed is 11.4 fps. For an arm or manipulator though it could be implemented.
Last edited by Jeff K. : 20-04-2007 at 16:47. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Offseason gearbox project... maybe this gearbox has helical gears? | Travis Covington | Technical Discussion | 17 | 05-06-2006 11:48 |
| Adapter for FP gearbox | Nitroxextreme | Motors | 1 | 28-01-2006 17:36 |
| request for info on gearbox gears | jskene | Technical Discussion | 0 | 08-01-2005 18:07 |
| gearbox for atwood motors | DaveG702 | Motors | 3 | 17-12-2002 10:30 |
| Specs for drill motor gearbox? | archiver | 2000 | 4 | 23-06-2002 22:36 |
Threaded Mode