|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#16
|
||||
|
||||
|
Re: pic: FVC 2013 Gear shifter
Thanks for posting this. I came up with a 10" wide version of this for a single side and couldn't figure out how to get it down to 9". Going length-wise just might be the key depending on the game and the robot's necessary manipulator clearance. Unfortunately with this design, it's not very plausible to add another 1-2 motors to each side without adding an entire new shifting mechanism.
If I ever get my current concept idea done I'll rebuild the old (10") design and show you what I mean -- 3 motors per side and it could push 40lbs of books across my carpet if I pushed down on the back of the bot with my finger for traction. (5:3 High and 1:6 Low) Last edited by JesseK : 27-04-2007 at 13:02. Reason: details |
|
#17
|
||||
|
||||
|
Re: pic: FVC 2013 Gear shifter
This design is relatively compact. It is 1" wider than a square robot, and the same length as a square bot.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FVC]: [FVC]: [FVC]: [FVC]: [FVC]: Vex Slider Parts | Thiele | FIRST Tech Challenge | 1 | 06-04-2007 10:00 |
| pic: 1732's 2 servo shifter | John Wanninger | Extra Discussion | 1 | 04-03-2007 23:27 |
| pic: team 1029 shifter | bjimster1 | Robot Showcase | 4 | 21-02-2006 10:23 |
| pic: AM shifter mount close up | falconmaster | Extra Discussion | 2 | 18-01-2006 19:27 |
| pic: Vex 2 Speed Mesh Shifter | Matt Krass | Extra Discussion | 11 | 17-10-2005 20:58 |