2006 Kit of Part Transmission

[artdutra04]

Here's the link to IFI's CAD model of the 2005/06 Season Kit transmissions:

http://ifirobotics.com/docs/Drivetra...rts%20STEP.zip

Originally Posted by Pnakovich

yup, this looks very good. Thank you, I appreciate this, i tried to make it but was unable to find the info to build the inards. this helped out alot.

If you have access to CNC fabrication services, it would be easier to reproduce the AndyMark single-speed transmission as opposed to the IFI ones.

The AndyMark transmissions are essentially exactly the same as the IFI trannies*. The IFI transmissions however used a custom cast aluminum plate (which would be much harder to reproduce), whereas the AndyMark transmissions have two machined 3/16" aluminum plates, with a piece of square box aluminum around the outside. (You could probably eliminate this square box and just use aluminum hex/round stock as spacers if needed instead.)

* The IFI transmission had a 12.755:1 ratio, where as the AndyMark has a 12.75:1 ratio.