|
|
|
 Hmmm... I'm pretty sure that twig isn't legal, since the tree it came from started fabrication before kickoff.... - lukevanoort [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Hmmm... I'm pretty sure that twig isn't legal, since the tree it came from started fabrication before kickoff.... - lukevanoort [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#16
21-05-2007, 10:05
|
||||
|
||||
|
Re: Bench Top Machines
If you need a small (foot square type stuff) leightweight, light duty cnc vertical mill or lathe, DeskCNC/IMService has some nice ones (check them out here, price list bout 1/2 down the page)
The average price is about $2500 bucks, but their lathes run from $775 to about $1500, and the mills run from $880 to about $4500. I have a large CNC gantry machine (15' x 5' x 1' travel) i've been working on completing that i'll be installing a desk CNC controller in this summer, so, more on that story later...  -q 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What machines are you using? (CNC, lathes, mills, 3-in-1 machines?) | MrB | Technical Discussion | 17 | 03-11-2006 11:55 |
| making a bench top PSU with a old school PSU | John Gutmann | Technical Discussion | 11 | 19-10-2006 09:54 |
| pic: Top Gun Top Wheels | Rick TYler | Robot Showcase | 4 | 04-02-2006 11:13 |
| Bench top CNC suggestions | Andrew Schuetze | General Forum | 6 | 08-12-2004 22:48 |
| Sewing Machines | tenfour | Kit & Additional Hardware | 0 | 07-01-2003 17:16 |
Threaded Mode