|
|
|
 There's so much to say about a sponsor who gets involved and cares about your team over one who just signs a check. - galewind [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| There's so much to say about a sponsor who gets involved and cares about your team over one who just signs a check. - galewind [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Strength of CIM Case?
Does anyone know how strong the case of the small CIM is? I'm working on a drivetrain to play in an off-season, and I'm currently mounting the DeWalt/CIM combo using a pair of U-bolts. Look at the attached pic to see how this works. (Yes, the U-bolts are exactly the right size to hold the CIM.
 ) For various reasons, I would like to move one bolt further up the CIM case, probably 1/2 inch from the back. The CIM seems pretty solid, but I don't want to damage it. Is tightening the U-bolts likely to dent the case or otherwise cause problems?Thanks! |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Chain Strength Formula | Molten | General Forum | 5 | 18-04-2007 15:01 |
| Servo Strength | TJ4nier | Motors | 20 | 13-02-2007 02:59 |
| Championship Division Strength | Rob | Championship Event | 26 | 06-04-2006 18:19 |
| Strength of welds on gears | sanddrag | Technical Discussion | 16 | 30-01-2004 17:32 |
| shear strength | Andrew Dahl | Technical Discussion | 1 | 14-02-2002 10:02 |
Threaded Mode