|
|
|
 Ironically, I think the best testament to the program [Dean Kamen] founded and his ideals wouldn't be if he won a Nobel Prize. It would be if you did. - Kevin Sevcik [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Ironically, I think the best testament to the program [Dean Kamen] founded and his ideals wouldn't be if he won a Nobel Prize. It would be if you did. - Kevin Sevcik [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
Getting two Vex controllers to "talk" to each other
I was wondering how I could get two vex controllers to talk to each other in easyc pro. I have an idea but it seems rather ineffecient and time consuming and I was wondering if there was a way to do it through either the tx,rx, or serial ports on the controller?
|
|
#2
28-05-2007, 11:59
|
||||
|
||||
|
Re: Getting two Vex controllers to "talk" to each other
just use the serial ports. There isn't much more I can say about doing it. just hook the rx to tx and tx to rx. Then just send what you want. If your talking about send packets too or using a protocol that is a whole different story. Just make sure both serial ports use the same baud rate.
-John |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Chicken wire(Mesh) "Tangled in other robots?" | andrew_4_life | Technical Discussion | 12 | 25-01-2006 00:39 |
| Stop The "Lesser of two evils" | MattK | Chit-Chat | 8 | 07-08-2004 23:31 |
| pic: Lavery and his "other car" | CD47-Bot | Extra Discussion | 11 | 03-05-2004 11:24 |
| Coolist "bot" in each division | Michael King | Championship Event | 46 | 21-04-2003 18:20 |
Linear Mode
