|
|
|
 Well, we put it in the bag at 11:58 last night. Needless to say we had to pull guys off of it to put it in the bag. I hope we didn't miss somebody and bag him up too. - jimwick [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
01-06-2007, 11:22
|
||||
|
||||
|
Re: innovation first breaker panel
It has two serial port interfaces, but only one serial device.
The Standard DB-9 port and the PWM port TX, RX, GND. Of course IFI says you shouldn't use the PWM connector. They didn't say you can't however. http://www.ifirobotics.com/forum/viewtopic.php?t=165 The serial port is used to send info about which breakers are tripped to the RC. The default MPLab code already has support for that data. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Innovation First Breaker Panel | falconmaster | Electrical | 3 | 25-08-2006 13:51 |
| Breaker Panel Diagnostics | dm0ney | Programming | 4 | 29-03-2005 19:00 |
| Bad Breaker Panel? | jdiwnab | Electrical | 5 | 14-02-2005 14:45 |
| Digital Breaker Panel | Mark McLeod | Control System | 8 | 31-01-2005 00:22 |
| Breaker Panel | Gal Longin | Electrical | 1 | 13-01-2005 16:01 |
Threaded Mode