|
|
|
 Keep in mind that the lady Amanda has just taken a new job, moved herself to the NorthEast, and has to put up with people like Grady, Needel, the Kelsos, and Boucher. Let's give her some patience and sympathy. - Andy Baker [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
30-06-2007, 22:41
|
|||
|
|||
|
Re: custom control programming question...
I think that the OIs measure voltage, not resistance. If this is the case (its been a loooooooong time...), you need to connect one end to +5, one end to ground, and the middle pin to the input. This forms a voltage divider.
good luck! |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Custom Pneumatics - Control Board Selection? | Erin Rapacki | Electrical | 3 | 03-04-2007 17:21 |
| pic: brand new custom built control center | eshteyn | Extra Discussion | 35 | 14-01-2007 22:49 |
| Custom programming cable | thegnome | Programming | 2 | 07-02-2004 17:07 |
| Custom Control Box | D.Viddy | Programming | 3 | 15-02-2003 11:35 |
| White Paper Discuss: VB .NET Dashreader custom control source | CD47-Bot | Extra Discussion | 2 | 19-01-2003 19:32 |
Threaded Mode