|
|
|
 ...after all these years Dean is still on message, and the message still resonates. - Richard Wallace [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| ...after all these years Dean is still on message, and the message still resonates. - Richard Wallace [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Looking for a supplier of Keyed Aluminum Shaft
Our team has been experimenting with arm designs and different ways to power them. Our current supplies, as far as a spocket set up goes, are completely iron. We've ordered aluminum sprockets, which cut the weight by50%, if not more. We're were wondering if we could use aluminum for the shafts. We've looked around quite a bit but can only find keyed shafts made of steel or an alloy of steel. We were wondering if anyone had a supplier or maybe knew of a different material , similar weight-wise, to aluminum. Any help would be useful.
Here is what we're looking for: Keyed Aluminum Shaft 3/4" in diameter 3/16" key width 1/16" key depth Thanks again, 545 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Looking for a keyed sprocket | Jeff Waegelin | Technical Discussion | 16 | 30-01-2007 14:45 |
| Matching a Gear to Keyed Shaft of DC Motor | Spindle | Motors | 9 | 22-05-2005 20:23 |
| 5/8 keyed shaft trouble | dddriveman | Technical Discussion | 14 | 18-05-2004 09:49 |
| supplier for 5/8" shaft | david.clark | Kit & Additional Hardware | 2 | 17-01-2004 18:13 |
| Looking for aluminum wire | archiver | 2000 | 5 | 23-06-2002 23:48 |
Threaded Mode