|
Re: Vex Programming Question
Quote:
Originally Posted by 1885.Blake
KingofI337 says below (thank you King) that older versions of EasyC had a hidden linkage between PWM Control and whether or not the microcontroller (plus the implied receiver...) detected a valid signal from a transmitter. He says this is gone from more recent Vex EasyC versions.
.............
So, for purely autonomous operation (no Transmitter needed) I think you remove all PWM Control commands and replace them with Motor/Servo Module commands.
|
We're using the EasyC v2.0 upgrade, and we're not able to run autonomous programs with motor module commands unless we turn on the transmitter. I don't know if purchasing v2.0 from scratch produces better results.
__________________
He is no fool who gives what he cannot keep to gain that which he cannot lose. - Jim Elliot
|
For FIRST robots, the phenomena listed above just do not apply. - Paul Copioli [more] 
08-07-2007, 18:41
Similar Threads
Threaded Mode