|
|
|
 I don't remember who said it or what the words are exactly...(I think it was Hopalong Cassidy) Don't say goodbye, just say see you later. - Al Skierkiewicz [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I don't remember who said it or what the words are exactly...(I think it was Hopalong Cassidy) Don't say goodbye, just say see you later. - Al Skierkiewicz [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
17-07-2007, 01:40
|
|||
|
|||
|
Re: Inventor > G-Code - HOW!!??
Inventor will export as DXF. You need to create an IDW drawing first.
To make G-Code, Flashcut and Ace DXF Converter are some free programs out there. SheetCAM is pretty nice for 2D and is inexpensive. MasterCAM is the full featured high dollar package used in many shops. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how do i get inventor? | GMKlenklen | Inventor | 6 | 17-11-2006 21:07 |
| how to convert Easy C code into real code? | TheHolyLancer | Programming | 1 | 29-01-2006 09:09 |
| How to Stack Tetras in Inventor | petek | Inventor | 0 | 13-01-2005 11:47 |
| How did you learn how to use Inventor? | Greg McCoy | Inventor | 26 | 24-05-2003 01:55 |
| How do i make gears in inventor? | mnkysp6353 | Inventor | 1 | 16-01-2002 02:31 |
Threaded Mode