pic: Custom Machined Aluminum #25 Sprocket

In fact, our robot YOLOs so hard it does drive-bys on the refs. - TrevorKN [more]

		Chief Delphi > ChiefDelphi.com Website > Extra Discussion
pic: Custom Machined Aluminum #25 Sprocket

Thread Tools

Rate Thread

Display Modes

26-07-2007, 21:09

Holtzman

Sometimes...

AKA: Tyler Holtzman

FRC #2056 (OP Robotics)

Team Role: Engineer

Join Date: Apr 2003

Rookie Year: 2003

Location: St. Catharines

Posts: 179

Re: pic: Custom Machined Aluminum #25 Sprocket

Machining time was a little over an hour. 1 setup on the mill. Holes were tapped by hand afterwards. Slight tooth chamfer was done on the lathe afterwards.

Was it worth the time? Probably not, but they do look nice.

__________________
"making the simple complicated is commonplace; making the complicated simple, awesomely simple, that's creativity." - Charles Mingus

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: MVRT1115 small machined parts	Ashwin	Extra Discussion	5	23-02-2007 13:22
pic: 254/968 Machined Parts	Cory	Robot Showcase	11	12-02-2007 07:42
pic: Team 1538's Machined Parts (C)	Jon Jack	Extra Discussion	19	23-01-2007 02:06
pic: 1538's Machined Parts (B)	Jon Jack	Extra Discussion	2	21-01-2007 20:31
#25 Aluminum Sprocket Source	Don Wright	Kit & Additional Hardware	1	26-01-2005 13:41

All times are GMT -5. The time now is 12:20.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.