Working from Drawings: A Challenge

[Cynette]

A comment on the holes...

I count 8, the description calls out 7 places. I'll admit that I'm not up to date on dimensioning drawings, is this now read "this hole gets this dimension, now look for 7 others and do the same?" Or is the other hole listed somewhere else and is different for error-proofing?

[Madison]

Originally Posted by Cynette

A comment on the holes...

I count 8, the description calls out 7 places. I'll admit that I'm not up to date on dimensioning drawings, is this now read "this hole gets this dimension, now look for 7 others and do the same?" Or is the other hole listed somewhere else and is different for error-proofing?

Good catch. I added a hole to the model after I first dimensioned the drawing and failed to update the note.

[DonRotolo]

OK, now I'm either genius or insane. (Likely the latter)

The bottom 90 bend is "up", the next bend (44) is "down" and the last us "up" again.

But the side view shows these as Up, Up, Down. (CCW, CCW, CW)

Can you help me understand what I am missing here?

Don

[Cynette]

Originally Posted by Don Rotolo

The bottom 90 bend is "up", the next bend (44) is "down" and the last us "up" again.

But the side view shows these as Up, Up, Down. (CCW, CCW, CW)

By Jove, I think you're right! That is how it looks!

[Pnakovich]

so which is supposed to be followed up, up, down or up, down, up

[DonRotolo]

Trust the darwing more than the words. If this was the real world, the guy trying to fabricate a sample, if he couldn't clarify with the designer, wouold use the drawing. Up Up Down until Madison clarifies.

Don