Consolidating PWM's to one serial cable

05-08-2007, 22:19

GMAdan

Team member turned mentor

AKA: Daniel A. Cobar

FRC #1881 (GAMMA Elite)

Team Role: Mentor

Join Date: Dec 2006

Rookie Year: 2006

Location: Paterson, NJ

Posts: 110

Re: Consolidating PWM's to one serial cable

from Ifi robotics
General Notes:

1. The red wire (center pin) on the PWM cable connected to the Victor is an open circuit. There is no reason to disconnect this wire in the cable. The Victor does not source or draw power on this line.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
home-made pwm's?	darkorbit	Electrical	2	17-02-2007 20:06
usb to serial cable	karinka13	Technical Discussion	4	10-02-2006 17:30
USB-Serial Cable + Terminal	Spencer E.	Programming	3	22-01-2006 12:16
Bluetooth serial cable replacement	seanwitte	Technical Discussion	2	13-02-2004 17:25
Serial Cable	Andrew Rudolph	Technical Discussion	9	15-08-2002 22:09

All times are GMT -5. The time now is 06:52.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.