|
|
|
 We've done that autonomous. After several years of refinement we decided to skip the information collection and just drive into the wall at the earliest opportunity. - Greg Young [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#26
27-08-2001, 19:29
|
|||||
|
|||||
|
This weekend we were runing the robot alot at our local mall. We ran if for about 2 hours straight and we had no poblems with heat. Since our drivetrian didnt have much strain on it i dont think it was a good test, but we never had any problems with our drivetrain, save a busted tranny from a nasty fall. But otherwise it was good, even when we ground our wheels down by pushing files into the wheels while running fullspeed. We just made nice aluminum motor mounts what alot of air can pass through. That probably helped.
Andrew |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PWM and burning out motors | patrickrd | Technical Discussion | 7 | 19-06-2003 15:30 |
| Looking for practice motors & extra tape drive parts? | archiver | 2000 | 1 | 23-06-2002 22:54 |
| Suppose you want seat motors... | archiver | 2000 | 0 | 23-06-2002 22:50 |
| Complete Drill, Seat, and Window motors for trade | archiver | 2000 | 0 | 23-06-2002 22:16 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
Threaded Mode