paper: Robot Recipes: A Cookbook Approach to Building with Vex

[ManicMechanic]

Thread created automatically to discuss a document in CD-Media.

Robot Recipes: A Cookbook Approach to Building with Vex by ManicMechanic

[ManicMechanic]

For the Chin-upbot, (project #2), under "Parts to cut", the instructions for cutting of angle bars are wrong.

The INCORRECT version currently reads:
Cut 3 X 15” angle bars into 2.5” + 12.5” (on the notch) – only the 2.5” pieces are used
Cut 1 X 15” angle bar into 5” + 10” (on the notch) – only the 10” piece is used

The CORRECT version should read:
Cut 3 X 15" angle bars into 5" + 10" (on the notch) - only the 5" pieces are used
From one of the remaining 10" pieces, cut one 7.5" piece (on the notch -- this is the center section)


My apologies -- I hope the error doesn't cause too much frustration & wasted metal. In our eagerness to start on the Challenge, we were a bit hasty in wrapping up this project.

[wilsonmw04]

even with the mistakes, this paper has been great for my FTC team. It's our second year but i graduated all my members from last year. It has given us a starting point for our design. Thanks again for sharing your knowledge.

[ManicMechanic]

A greatly expanded version of building instructions, renamed Vex Machinations, is now posted here: http://www.vexrobotics.com/vex-educa...esources.shtml.

It has 16 projects that fall into 3 categories: Vex Starter Kit projects, Beginning Programming projects, and Advanced Mechanical projects.