|
|
|
 I don't thinks shorts should be allowed in the pits. Remember to insulate all of your wires! - Jalerre [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| I don't thinks shorts should be allowed in the pits. Remember to insulate all of your wires! - Jalerre [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools |
Rating:
|
Display Modes |
|
|
|
#1
|
||||||
|
||||||
|
Re: Drafting standard ANSI Y 14.5 Detail & Section view question
I don't have my book in front of me but I don't recall anything on the topic. I would not use the same label for a detail and a section, just for clarity. I think the only case which I would use the same labels for both is if they were included in the same feature, such as an undercut detail call out where I also show a section view to get the geometry. People naturally associate letters so it wouldn't be good practice to use the same labels for un-associated details.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| question more detail intsructions | oakleafmeg | Programming | 1 | 11-01-2007 20:22 |
| Question on section 5, <R58> | ryan_f | Electrical | 10 | 06-02-2005 05:23 |
| Error - section 'UTIL_LIB' can not fit the section. Section 'UTIL_LIB' length=0x00000 | BookerT | Programming | 13 | 27-01-2005 09:49 |
| Error - section 'UTIL_LIB' can not fit the section. Section 'UTIL_LIB' length=0x00000 | BookerT | Programming | 0 | 25-01-2005 19:17 |
| pic: 217 Gen 2 Crab Module Section view | CD47-Bot | Robot Showcase | 2 | 28-04-2003 18:26 |
Hybrid Mode
