|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
|
||||
|
||||
|
Re: [OCCRA]: we need a preinspection form
No you can't get DQ'd for drilling speed holes. In most cases you lose very little weight, and weakens the structure of what you are "swiss cheesing", therefore it's not a good solution to losing weight. You see alot of teams doing this when they are 5 pounds over weight, when they can be spending thier time better by looking at what they can take off. Hope this helps but if you want an official answer then post it in the Q & A section.
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| BOM form | Adama | General Forum | 3 | 08-03-2007 16:28 |
| Bill Of Materials Form | orelinde | General Forum | 12 | 26-02-2007 13:51 |
| Release Form | kjohnson | Championship Event | 4 | 27-01-2004 16:21 |
| Form? | Lisa Huang | Chairman's Award | 1 | 16-02-2002 02:24 |
| Submission Form | Maddie N | Chairman's Award | 0 | 06-02-2002 20:39 |