|
|
|
 You can't unwind after build season knowing that competition season is just around the corner! ;) - Hallry [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| You can't unwind after build season knowing that competition season is just around the corner! ;) - Hallry [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
22-10-2007, 19:23
|
||||
|
||||
|
Re: Operator Interface Troubleshooting
That's a good thought, but I know at least one Victor is functioning correctly because the motor does turn, but I assumed it was just turning because it wasn't calibrated correctly (or the trim is off). It does not vary with time or any change in the controls. And again, the joystick was also hooked up to a servo which won't move. Also, I neglected to mention that I also coded it to turn one of the relay led's to green when the trigger switched was clicked, and nothing happened.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| operator interface | carbuff | Rules/Strategy | 1 | 18-02-2007 09:06 |
| operator interface | tml240 | Electrical | 5 | 10-02-2004 17:50 |
| Operator Interface Heads Up | Madison | Robotics Education and Curriculum | 6 | 11-12-2002 06:59 |
| operator interface board | archiver | 2001 | 4 | 24-06-2002 00:33 |
Threaded Mode