|
|
|
 we need a diverse team, and until we can welcome someone that's not a nerd, I don't think we're really successful in our recruiting. - JBotAlan [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| we need a diverse team, and until we can welcome someone that's not a nerd, I don't think we're really successful in our recruiting. - JBotAlan [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Deventeh Digatal - CMPS03 - Robot Compass Module
I am in desperate need of help, I have been trying to integrate this compass for a while now with out any luck. At first we used interrupt code to read it, but the RC loop was too slow and did not give a accurate reading.
The compass has two interfaces, I2C, PWM. The PWM method is the one that did not work. Now since the RC is not compatible with I2C we bought a converter, it converts I2C to RS232. That means we have to connect it though the TLL port. But I have not experience with programming that port. Can anyone help me out. Anyone? Thank You! |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programming a Devantech Magnetic Compass - CMPS03 | kE7JLM | Programming | 7 | 28-09-2007 08:23 |
| Interfacing a digital compass with the RC | Kelly | Electrical | 14 | 27-09-2007 19:01 |
| I2C Digital Compass Programming | CyberWolf_22 | Programming | 7 | 03-01-2005 00:20 |
| Political Compass | Joshua May | Chit-Chat | 11 | 01-10-2004 22:32 |
| Compass/direction sensor | Frank(Aflak) | Technical Discussion | 10 | 06-04-2003 09:18 |
Threaded Mode