Last Year's Gear Ratio

Doug G · #1 11-11-2007, 00:34

Also for this to be meaningful, you may want to consider which motors are being used for driving. While many use CIM's, some also use FP's and/or the mini-bike CIM (fat chip). Therefore the gear ratios used for those motors should not be compared with other motors.

We used 12:1 Banebots with the DUAL CIM configuration and additional 1.3:1 geardown to the 6" wheels for a total of about 16:1. The results end up with 6.25 ft/s at 40 Amp draw and 9 ft/s at free speed. No shifters last year.

AdamHeard · #2 11-11-2007, 01:17

We had a Small CIM, big CIM and FP w/ AM planetary on each side. The ratio of the Small CIM (which the other motors were matched to) was about 12:1.

This was driving 6 inch wheels.

View Poll Results: What was your final gear ratio on your drive?
< 10:1 (not inclusive)	0	0%
10:1 (inclusive) to 12:1 (not inclusive)	0	0%
12:1 (KOP)	6	37.50%
12:1 (not inclusive) to 15:1 (inclusive)	2	12.50%
> 15:1 (not inclusive)	4	25.00%
Multispeed (Post your gear ratios)	4	25.00%
Voters: 16. You may not vote on this poll

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Transmission gear ratio	MASherry	Technical Discussion	6	13-01-2005 10:32
Help with gear ratio	Wayne C.	General Forum	6	26-01-2004 12:30
Helical Gears Gear Ratio	Joe P	Technical Discussion	11	23-01-2003 22:55
gearing for last year's gear cluster for the chipuhua motor	Antonio	Motors	0	07-01-2003 15:31
Gear Ratio Doesn't Matter	Paul Copioli	Technical Discussion	2	27-09-2001 08:18