|
|
|
 Dean looks rather debonaire in a tux. Like some sort of engineer super hero. The tuxedo is like his Clark Kent costume under which lies his amazing denim suit, to be whipped out at a moments notice in the face of uninspired youth and problems unconquered. - phrontist [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
14-11-2007, 14:07
|
|||
|
|||
|
Re: IFI Traction Wheel stationary?
I do have a lathe so it will make things easier.
Correct me if I am wrong but: If you machine a 1/2" hex axle down so that it is completely round it will be much smaller than 1/2". So would a 3/8" inner diameter bearing be in order? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| IFI traction wheels | rachal | Technical Discussion | 10 | 17-04-2007 22:01 |
| IFI Traction Wheels V2 Testing Results | Holtzman | Technical Discussion | 15 | 14-01-2007 23:28 |
| IFI Traction Wheels | chris31 | Technical Discussion | 4 | 23-12-2006 09:25 |
| Reducing wheel traction | dude__hi | General Forum | 18 | 29-03-2004 18:43 |
| WHEEL TRACTION--PLEASE RESPOND | archiver | 2001 | 7 | 24-06-2002 00:36 |
Threaded Mode