|
|
|
 Engineers crave and demand facts, and won't reach a conclusion without them. - Richard Wallace [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Engineers crave and demand facts, and won't reach a conclusion without them. - Richard Wallace [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
11-12-2007, 08:35
|
||||
|
||||
|
Re: pic: 114's new tensioner
It looks great. I would be concerned with the tension bolt loosening. Instead of using a bolt for tensioning, you cold use a threaded rod with a hex insert at the end for an allen wrench. Then by tapping the end plate on your 2x1 extrusion, you can put another nut on so it would be double nutted.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Kitbot Chain Tensioner 2 | Donut | Extra Discussion | 13 | 10-12-2007 15:57 |
| pic: 114 6wheel tensioner | CraigHickman | Extra Discussion | 12 | 04-12-2007 01:32 |
| pic: Kitbot Chain Tensioner 1 | Donut | Extra Discussion | 6 | 21-12-2006 00:43 |
| pic: 114's electronics box | CraigHickman | Extra Discussion | 0 | 15-02-2006 09:35 |
| pic: 114's robot (UNCENSORED) | CraigHickman | Robot Showcase | 20 | 13-02-2006 05:37 |
Threaded Mode